BITUMAT TOPSEAL is a finely formulated APP modified bitumen membrane designed for efficient and easy applications.
BITUMAT TOPSEAL waterproofing membrane consists of non-woven polyester reinforcement, impregnated and coated on both sides with APP modified bitumen.
BITUMAT TOPSEAL membrane is ideal for a wide range of waterproofing applications including roofs, car parks, reservoirs, etc.
BITUMAT TOPSEAL is available in two basic finishes :
1. Black smooth finish with polyethylene surfaces for covered applications.
2. Granule surfacing for exposed applications.
In addition to stringent regular test by BITUMAT laboratory, our products are tested periodically by Independent laboratories.
BITUMAT TOPSEAL is installed by torch welding method, loose-laid or fully bonded to substrate. When loose-laid, only laps are bonded together.
Peripheries and protrusions are sealed according to specifications.
Gas torch, knife, trowel, measuring tape, marking strings and gloves.
(Rate may vary as per site requirement)
Flat areas : 1.15 m2/m2 per layer with 10 cm. side laps and 15 cm. end laps Base flashing : 100x35 cm. with 15 cm. end laps, 0.40 m2/ Linear Meter Average wastage : 3 - 5 %The underside of the membrane should be torched just enough to superficially melt the bitumen. Excessive heating may damage the reinforcement. Overlaps should be re-heated from the top and resealed with a trowel to ensure seam integrity.
For details of installation methods and flashing requirements, consult the Bitumat technical department.
تأسست شركة بيتومات في عام 1984 ، ولكن جذورها تعود إلى عام 1975 عندما شارك المؤسسون في صناعة العزل المائي للأسقف بصفتهم تجاراًومركبين في المملكة العربية السعودية لشركة تصنيع رئيسية من الولايات المتحدة الأمريكية.