Bitumat

Home - Bituminous - Modified Bituminous Membranes - APP Modified - Topseal 200

TOPSEAL 200 - APP Modified Bitumen Membrane with 200 gsm Non-Woven Polyester

BITUMAT TOPSEAL 200 is a uniquely formulated prefabricated waterproofing membrane with a special multilayered design for superior pliability, tensile strength, workability and resistance to elements.

The multilayered design consist of a spunbonded polyester core coated on both sides with APP modified bitumen. The polyester core gives the membrane high tensile strength, elongation and superior lap joint strength.

Properly installed, BITUMAT TOPSEAL 200 forms an impervious, permanently flexible waterproof blanket which accepts normal structural movement without breaking or cracking.

Topseal 200

USER

BITUMAT TOPSEAL 200 membrane is ideal for a wide range of waterproofing applications including roofs, car parks, reservoirs, etc

FINISHES

BITUMAT TOPSEAL 200 is available in two basic finishes:

1. Black smooth finish with polyethylene surfaces for covered applications.

2. Granule surfacing for exposed applications.

QUALITY CONTROL

In addition to stringent regular test by BITUMAT laboratory, our products are tested periodically by Independent laboratories.

APPLICATION

BITUMAT TOPSEAL 200 is installed by torch welding method, loose-laid or fully bonded to substrate. When loose-laid, only laps are bonded together. Peripheries and protrusions are sealed according to specifications.

INSTALLATION TOOLS REQUIRED

Gas torch, knife, trowel, measuring tape, marking strings and gloves.

COVERAGE RATE (Approx.)

(Rate may vary as per site requirement)

Flat areas : 1.15 m2/m2 per layer with 10 cm. side laps and 15 cm. end laps Base flashing : 100x35 cm. with 15 cm. end laps, 0.40 m2/ Linear Meter Average wastage : 3 - 5 %

TORCHING GUIDELINES

The underside of the membrane should be torched just enough to superficially melt the bitumen. Excessive heating may damage the reinforcement.

Overlaps should be re-heated from the top and resealed with a trowel to ensure seam integrity. For details of installation methods and flashing requirements, consult the Bitumat technical department.

المصادر التقنية

تأسست شركة بيتومات في عام 1984 ، ولكن جذورها تعود إلى عام 1975 عندما شارك المؤسسون في صناعة العزل المائي للأسقف بصفتهم تجاراًومركبين في المملكة العربية السعودية لشركة تصنيع رئيسية من الولايات المتحدة الأمريكية.

B.I.R.A

مشاهدة الكل

أكاديمية الأسقف والعزل المائي الوحيدة في الشرق الأوسط! حضر الأكاديمية آلاف من الممثلين من مختلف أنحاء العالم وتخرجوا بمرتبة الشرف. يمكنك أيضاً أن تكون واحداً منهم.......