BITUMAT APP (attactic polypropylene) modified bitumen reinforced membranes are produced from a blend of special polyproylene thermoplastic polymers and distilled bitumen. This combination gives the proven waterproofing qualities of bitumen combined with plasticity, excellent resistance to heat aging and weathering and ease of application by torch welding
BITUMAT Saudi-made membranes offer total impermeability to water, outstanding bondability and seam integrity, easy repair and maintenance and the possibility of a wide range of decorative finishes for exposed application.
DOUBLE-TECH is a range of modified bitumen membranes which incorporates a special double reinforcement of 180 gsm nonwoven, spun bond polyester fabric and a 50 gsm glassfibre matt. This multi-layer construction is positioned within the mass of the modified (APP) bitumen coating.
The finished product is a general purpose high performance waterproofing membrane and vapour barrier with added qualities of dimensional stability and robustness.
DOUBLE-TECH with its unique combination of properties is ideal for use in heavy duty applications such as bridge & roof waterproofing, tunnels, tanking, vapour barrier etc. In fact, anywhere above and below ground where toughness, impact resistance and dimensional stability are required. It is an excellent vapour barrier.
DOUBLE-TECH is available in two basic finishes :
1. Black finish with sand surfacing for covered application. Thickness 4 or 5mm. 2. Coloured granule surfacing for exposed application. Granule finish DOUBLE TECH is available in various colours such as white, grey, red, green and mixed colours. Thickness 4 or 5 mm.In addition to stringent regular test by BITUMAT laboratory, periodic visits and Quality Control test are performed by:
1. Bureau Veritas, Paris, France
2. MASENCO, Hurst, Texas, U.S.A.
DOUBLE-TECH complies with the requirements and tolerance levels of UEAtc (European Union of Technical Agreement) MOAT 27-1983 and MOAT 30-1984 and CGSB (Canadian General Standards Board) 37-GP-56M-July 1980. ASTM D 6223 Type 1.
Gas torch, Knife, Trowel, Measuring Tape, Marking String, Gloves.
DOUBLE-TECH is installed by torch welding method, loose-laid or fully bonded to substrate. When loose-laid, only laps are bonded together. Peripheries and protrusions are sealed according to specifications.
(Rate may vary as per site requirement)
Flat areas : 1.15 M2 /M2 per layer with 10 cms. side laps and 15 cms. end laps. Base flashing : 100x35 cms. with 15 cm. end laps, 0.40 M2 / linear M Average wastage : 3 - 5 %The underside of the membrane should be torched just enough to superficially melt the bitumen. Excessive heating may damage the reinforcement. Overlaps should be reheated from the top and resealed with a trowel to ensure seam integrity.
For details of installation methods and flashing requirements, consult the relevant Bitumat Systems Design and Installation Manual.
تأسست شركة بيتومات في عام 1984 ، ولكن جذورها تعود إلى عام 1975 عندما شارك المؤسسون في صناعة العزل المائي للأسقف بصفتهم تجاراًومركبين في المملكة العربية السعودية لشركة تصنيع رئيسية من الولايات المتحدة الأمريكية.
© 2020 www.bitumat.com-ACT, All rights reserved. AI
