BITUMAT PREMIERFLEX-2000 is an SBS modified bitumen waterproofing membrane re-inforced with spunbonded polyester mat. The combination gives the proven waterproofing qualities of bitumen along elasticity, and excellent resistance to weathering and ease of application.
BITUMAT PREMIERLEX-2000 is a general purpose waterproofing membranes suitable for all water roofing applications (Roof and basement included). It can be applied in single layer or multilayer as specified.
BITUMAT PREMIERFLEX-2000 is installed by torch welding method, loose-laid or fully bonded to substrate. When loose-laid, only overlaps are bonded together. Peripheres and protrusions are sealed according to specifications.
(Rate may vary as per site requirement)
Flat areas : 1.15 M2 /M2 per layer with 10 cms. side laps and 15 cms. end laps. Base flashing : 100x35 cms. with 15 cm. end laps, 0.40 M2 / linear Mtr. Average wastage : 3 - 5 %The underside of the membrane should be torched just enough to superficially melt the bitumen. Excessive heating may damage the re-inforcement. Overlaps should be re-heated from the top and resealed with a trowel to ensure seam integrity. For details of installation methods and flashing requirements, consult the relevant BITUMAT Systems Design and Installation Manual.
Bitumat was founded in 1984 but its roots go back to 1975 when the founders became involved in the roofing waterproofing industry as dealer and applicator in Saudi Arabia for a major manufacturer from the U.S.A.
© 2024 www.bitumat.com-ACT, All rights reserved. AI
